Tools and Supplies I Recommend

If you follow my social media pages you know that i am fanatical about which tools and supplies work best in my shop.  I don't care about brand names, only which product works best without breaking the bank (too much).  The following are the items i have tested and endorse, full disclosure these are Amazon Affiliate links, which has NO BEARING on my recomendations! Buying through my links does however help me afford the time and oppertunities to test further products and make accurate recomendations.

 Here are products i use to tumble and debur my brass and copper items. One of the media options is for rounding and smothing, the other is to polish the brass should you desire. 

 

Here are the drill bits i use to drill out the finger stalls and more.  First one is great at cutting soft alloys such as brass and copper, remember to use low RPMs and oil, go slow.  Next ones are used for beveling the finger stalls as well as other useful bits to have on hand.

Related Posts

And it Begins!
And it Begins!
As i sit here setting up this new Blog page, i think back to how this all started and how far I've come.  As some of ...
Read More
Replace or Change your Co2 Laser Lens
Replace or Change your Co2 Laser Lens
Cleaning your Laser Lens can be a tedious job, however, it is incredibly important.  In this article i will tell you ...
Read More
How to Clean an In-Line Exhaust Fan
How to Clean an In-Line Exhaust Fan
If you own or operate a Co2 Laser then you know the importance of having a working exhaust fan.  Cleaning your fan ca...
Read More

Leave a comment

Please note, comments must be approved before they are published